Disclaimer: While we work to ensure that product information is correct, on occasion manufacturers may alter their ingredient lists. Actual product packaging and materials may contain more and/or different information than that shown on our Web site. We recommend that you do not solely rely on the information presented and that you always read labels, warnings, and directions before using or consuming a product. For additional information about a product, please contact the manufacturer. Content on this site is for reference purposes and is not intended to substitute for advice given by a physician, pharmacist, or other licensed health-care professional. You should not use this information as self-diagnosis or for treating a health problem or disease. Contact your health-care provider immediately if you suspect that you have a medical problem. Information and statements regarding dietary supplements have not been evaluated by the Food and Drug Administration and are not intended to diagnose, treat, cure, or prevent any disease or health condition. Amazon.com assumes no liability for inaccuracies or misstatements about products.
Haoshuo Product Page
CAS No. -65-3
Hydroxypropylmethylcellulose (HPMC) is a multifunctional lubricant, foam enhancer and stabilizer, thickener, emulsion stabilizer, and film-former for hair and skin care products.HPMC is particularly useful in surfactant systems, where it possesses foam-enhancing properties that contribute to the formation of a bubbly structure, resulting in richer, longer-lasting foams.HPMC has a high tolerance for salt and alcohol.
If you are looking for more details, kindly visit hpmc powder.
The preferred method is to begin by heating approximately 1/3 of the total formulation water to 167°F (75°C) or higher. Add the HPMC to the vortex of agitated and heated water. Mix until fully dispersed. HMPC will not dissolve at this temperature. After complete dispersion, add the remaining water at room temperature or colder and continue mixing for 30 minutes after the total solution has cooled to 77°F. (25°C) or less. Proceed with the formulation.
If heating is impossible, it is preferred to slurry the HPMC in a non-solvating media, such as glycerin or PEG, then add the slurry to the vortex of vigorously agitated water. Adding HPMC directly to cold water is not preferred, but if necessary, must be done very slowly under vigorous agitation. Expect longer mixing times for complete dissolution.
For more HPMC for building materials|CAS -65-3information, please contact us. We will provide professional answers.